Over the weekend I used some angle to create a frame for the
radio stack then measured out where to start cutting the panel. I had to consider the substructure very
significantly before cutting. Everything
has to fit together and the GTN 650 goes through the sub panel, so care needed
to be taken. I think I got it perfect,
I will need to work on the Skyview cutout and the sub panel, before everything
is solidified, but for now things are looking good. I cut the hole for the radio stack a bit
small so that the case frames seal up nicely, but I had to file out some
clearance areas so that the 650 and the PAR-100EX fit with needed clearance.
Over the weekend I used some angle to create a frame for the
radio stack then measured out where to start cutting the panel. I had to consider the substructure very
significantly before cutting. Everything
has to fit together and the GTN 650 goes through the sub panel, so care needed
to be taken. I think I got it perfect,
I will need to work on the Skyview cutout and the sub panel, before everything
is solidified, but for now things are looking good. I cut the hole for the radio stack a bit
small so that the case frames seal up nicely, but I had to file out some
clearance areas so that the 650 and the PAR-100EX fit with needed clearance.
No comments:
Post a Comment